Showing 689–704 of 4271 results
Early Minis were made by both Austin and Morris and while the cars were mechanically the same, they used different interior trim. The early Minis built before a more standardised interior built in 1962 had a wide variety of interior trim and if you are unsure of your requirements please get in touch with our…
These rear quarter panels did not have a pattern on them but are just covered in plain vinyl grey fleck material. These are the earlier type of panels fitted with screws and cup washers whereas the later panels fitted into the vehicle in the body mounted channel at the top of the panel (part number WA3101)…
These rear quarter panels did not have a pattern on them but are just covered in plain vinyl grey fleck material. These are the later type of panels that fitted into the vehicle in the body mounted channel at the top of the panel, whereas the earlier panels were fitted with screws and cup washers…
The rear pocket liners after November 1959 moved into this shorter less complex design for both the Austin Seven and the Morris Mini. They featured a cut out for both the ash tray and the interior light and were usually trimmed in the main trim colour of the vehicle which was most often Fleck. As…
These panels are designed to fit the early MKI models fitted with the round central single instrument speedo binnacle. They can be quite difficult to fit around the binnacle as they are curved into position and held in place by the material flap behind the draught excluder and the plastic binnacle itself. These come as…
In the early years of production manufacture was shared between two factories. While mechanically the same, the Austin Seven and Morris Mini used their own trim designs and these designs varied throughout these years until trim became more standardised after 1962. This design was used exclusively in Morris production and matches the seat covers with…
These carpets have been designed for those wishing to keep those rare early Minis as close to original specification as possible. Made as a flat lay carpet as per the original carpet set fitted into the early Morris Minis, they are made with the original style heel mat which we have had remade and also…
These door panels were used in the early Morris Minis only up until production in November 1959. They used a mixture of the painted and grained fibreboard on the bottom of the panel and the main trim colour within the vehicle on the top of the panel. This was as standard the Fleck material but we…
This style of rear pocket liner was only used in the early Morris Minis up until production in approximately November 1959. They were made from a black painted and grained board and included a cut out for the interior light and the ashtray. As with all early Mini items there was a lot of changes…
These rear quarter panels were used in the early Morris Minis only up until production in November 1959. They used a mixture of the painted and grained fibreboard on the bottom of the panel and the main trim colour within the vehicle on the top of the panel. This was as standard the Fleck material…
This original design of the seat straps was fitted to the very early seat post leg seat frames of the early Morris and Austin Minis. We make these straps in house with British manufacturing at its best. This kit is for the squabs only of both front seats.
This original design of the seat straps was fitted to the very early seat post leg seat frames of the early Morris and Austin Minis. We make these straps in house so these show British manufacturing at its best. This kit is for both front seats.
This foam set is for early rear seats that had seat covers that did not fit into the pockets and uses the more typical wheel arch covers. These covers were fitted before the introduction of the wire frame in the 1960 s for the Austin cars and for all Morris Minis fitted after 1960 and…
Early Series II Morris Minor Travellers used a a much more simple system of headlining than later Minors cars with metal stays and cables which hold the unit in the roof. These were glued directly to a wooden board that fitted in the roof – please note that the wooden boards are not included. Colours…
This chromed bracket is to secure the early Mini sunvisor with the central fixing location. Screws to fix to the roof are not included. This is supplied individually.
This chromed bracket is to secure the early Mini sunvisor with the central fixing location. Screws to fix to the roof are not included. This is supplied individually.
End of content
End of content
No products in the cart.
